Sultan Flora
$24.99 USD
Launching Soon!A commanding radial floral form with two rings of pointed leaf petals, fine detail lines throughout, and a scalloped outer edge that carries real presence in clay.
All sizes listed are approximate and given in millimetres. Minor variation is normal and part of the handcrafted nature of 3D printed cutters.
Clay thickness and slab preparation will vary depending on the design. As a general starting point, I work at approximately 3mm for most of my designs. More intricate, high-detail work may benefit from a thinner slab. Condition your clay thoroughly and press firmly and evenly for the cleanest result.
For my full technique guide including pasta machine settings, clay brands, and tips by design type, visit the Clay Guidelines page.
Rinse your cutter with warm water after use and allow to air dry completely before storing. Avoid acetone, harsh solvents, or prolonged heat exposure as these can affect the material over time. Store flat or upright in a dry place away from direct sunlight.
